Best selling wood projects - Making A Boat Paddle Tenor Ukulele Part 7 Neck Preparations

Best selling wood projects

Long time no uke .....
Where were we?
OK, the body shell sides are  ready and glued in place.
The neck block has to be made to accommodate the neck tenon.
I have chosen Australian cedar for this because of its lightness and strength.
The neck block has to be moulded to fit the shape of the top end of the body - it will also support both the top and back of the uke.

Cutting Out The Neck

I have made up the neck blank from three strips - two of sassafras and one of Australian rosewood.

 One end is cut to leave the middle piece of rosewood.  This will act as the tenon to anchor the neck and body together.

Here is the neck roughly laid out on the laminated blank.

The angle of the headstock to the neck is 15 degrees - easily measured with a protractor and angle gauge

After laying out the neck shape precisely, I cut it out on the bandsaw.

Here are the offcuts and the roughed out neck.  I keep the scraps - they will come in handy later.
All of the remaining shaping of the neck will be done by hand using rasps, spokeshaves and scrapers.

Ill move on to that next.
Happy shavings

Best selling wood projects

Read More..

Best selling wood projects - Making A Boat Paddle Tenor Ukulele Part 8 Making and Fitting the Body Linings

Best selling wood projects

The Hall Table is finished and gone to a good home.
Soooo - back to the Uke.

The body of the ukulele is complete as far as the sides go, but it needs a neck block.

I have made the neck block from Australian Cedar for its lightness, strength and tonal qualities.

The neck block is over large - as this end of the uke is a weak point on a cutaway design.
The neck block is glued in place.

I have been refining the body and getting things ready for the application of the linings.  These hold the top and bottom in place when they are glued to the body sides.
I made the linings on the tablesaw from a piece of paulonia.

The kerfed timber was then cut into strips on the bandsaw.

The full story of making the linings can be found here:
http://thevillagewoodworker.blogspot.com.au/2012/06/building-ukulele-part-1-timber.html
I had made enough when I constructed my first ukulele, to have sufficient for a few more ukes.
The linings are held in place by clamps and pegs until the glue is dry.

 

This is done one side at a time, to allow the mould to support the body, and for it to project enough to apply the clamps.

Once  the top is done, the mould is flipped over and the process repeated for the bottom.

Inevitably there is excess glue that needs cleaning up, as well as any bumps from the linings that project above the edges.
This is easily attended to with a small block plane.
Enough for today.
Next time Ill look at the front and the back.
Happy shavings to all.





Best selling wood projects

Read More..